I have an zing 50 about 10years old. The problem I am having is as follows:
When engraving I get about 1/3 of the letters burned then the unit returns home as if its done. It also acts if home for the burn is upper left corner, not center or anywhere else.
Vectoring is fine no issues on centering in the project or completing the burn. What I've done:
Replace the flex cable (X,Y) in the unit, twice, the cable from PC to the unit twice, verified the IP address for the machine and PC. (The PC is isolated from the network and is direct connected to the laser.)Tried printing from two different programs with the same result.
Epilog support looked it over and is at a loss for a solution.

Any other Ideas?
Thanks in advance......