Miter gauge slots in an outfeed table

[Jason White]

Here's a little video showing a jig I threw together so I could cleanly rout some slots in the top of my outfeed table. Beginner-level stuff, but I imagine we have a few in the group. Hopefully it helps somebody. Have a great weekend!

https://youtu.be/UbLM8bSR3GM

[David Buchhauser]

Very nicely done!
David

[Maurice Mcmurry]

Liked and subscribed. You have a nice, tidy, well thought out space.

[Matt Day]

Your method is a lot more complicated than mine, which is a board clamped to table as a guide.

[Ole Anderson]

Nice job, I always enjoyed making jigs, others see them as a needed waste of time.

[Jason White]

Thanks, Ole! I used to dread making jigs but now I think it’s kinda fun.

Nice job, I always enjoyed making jigs, others see them as a needed waste of time.

[Jason White]

I’ve done that, too. But I find this method to be a bit more goof-proof.

Your method is a lot more complicated than mine, which is a board clamped to table as a guide.

[Jason White]

Thanks, Maurice! It’s taken me a lot of years to get my shop to this point.

Liked and subscribed. You have a nice, tidy, well thought out space.

[Alan Schwabacher]

It looks good. For those without room for a full sized permanent outfeed table, one that folds down is nice. In that case, a short one with grooves can be hinged to a longer part without grooves. Even a very short outfeed table is useful.

[Bruce Page]

Slick jig Jason. My method was similar to Matt’s. What I’m really impressed with is the dust collection on your router. MDF is horrible stuff to route!

[Edward Weber]

"My wife asked me to take her to one of those restaurants where they make the food right in front of you. So, I took her to Subway and that’s how the fight started."
thanks for the laugh, SWMBO liked it

One suggestion on the out-feed table is to use Melamine, if possible.
It reduces friction and wears pretty well.
img_6287.jpg
The slot is for the splitter/blade guard, the 3 small holes are leveling screws.
Just some suggestions

[Kris Cook]

Nice job of presenting

[Jason White]

I applied poly and paste wax to the MDF. Works great.

"My wife asked me to take her to one of those restaurants where they make the food right in front of you. So, I took her to Subway and that’s how the fight started."
thanks for the laugh, SWMBO liked it

One suggestion on the out-feed table is to use Melamine, if possible.
It reduces friction and wears pretty well.
img_6287.jpg
The slot is for the splitter/blade guard, the 3 small holes are leveling screws.
Just some suggestions

[Matt Day]

What I really need to do is get a router attachment to mount the router in my Festool tracks. That would work great for this type of task.

[Alan Lightstone]

I've used Formica sheets glued to the top of baltic birch plywood sheets precut and glued with the slot thickness already established. The issue is avoiding tearout, then routing the slots with a pattern bit. Not impossible, but I'm not sure I'd do it again that way.