I have some drawer faces that will wind up @ 9-1/2" tall by 19-1/2" wide. When I glue up drawer faces I try to use two pieces that are similar in size 5" x 5" and trim from both edges to get the say 9-1/2 vs a 7" and 2-1/2". I have some 8" wide stock that is "left over" that I can get two faces from and add to them to get the 9-1/2 total after milling etc..., but I am concerned how this would look cosmetically. Similar coloring and I would do my best to get grain match etc..., but I am concerned about splitting the 9-1/2 up this way.
Thanks for your input.
Brian