Well, it has been quite some time; but work has finally started on the new shop addition I previously posted about. I mentioned in an earlier post that the goal was to get the shop out from the basement and to accommodate a larger stroke sliding table saw and possibly CNC. For a number of reasons, the property did not support a separate building so I ended up adding an addition to our walkout basement of approximately 320 Sq/Ft where I will do bench and non-large machine work. Here’s a concept drawing of the outside and a pic of work starting.


p1.jpgp2.jpgp3.jpg

To do this I moved my existing equipment out of the corner of the basement to a space adjacent to the new addition. Here’s a pic of the old space. And a photo of the new space where the equipment has been moved. I’ll post a pic of the new layout once all the clutter is relocated.


p4.jpgp5.jpg


Best,
Sal