I have the fixed base and want to put it on the router. Removing these four screws should allow me to pull the motor out of the plunge base? Nothing in their manual.
Thanks.
Brian
freud ft2200.jpg
I have the fixed base and want to put it on the router. Removing these four screws should allow me to pull the motor out of the plunge base? Nothing in their manual.
Thanks.
Brian
freud ft2200.jpg
Brian
Sorry can not help with your question, I am not familiar with Freud routers. Question number one - is your router compatible with any bases for router table?
Ed.
I couldn't find a listing for an FT2200. On my Freud FT2000, to remove the motor portion from the base you unscrew the depth adjust knob and slide the motor up off the tubes. The tubes are pinned into the base plate. I believe the screws you are looking at will disassemble the motor based on the parts explosion Your router looks very similar to the FT2000 VCE.
Can you post a picture of the fixed base?
Last edited by Lee Schierer; 03-12-2022 at 3:41 PM.
Lee Schierer
USNA '71
Go Navy!
My advice, comments and suggestions are free, but it costs money to run the site. If you found something of value here please give a little something back by becoming a contributor! Please Contribute