Originally Posted by
Warren Lake
I know you know high speed steel.
I measure to the tip of the knife as that is what is cutting. ive had a dial on enough heads to see some have a dip on the head as you approach the knife opening. I zero on the head then as rotating sometimes see a dip maybe .004 as im close to the opening.
What is your knife projection from the head being zero to the tip of the knife? I figured I pushed it low enough at .050 as i set up now, at some point there will not be enough projection, im sure im still fine as never any issues and it cuts cleaner than when i started high and worked down. If you have a few minutes at some point will you check that number.
and
now thinking what about Tersa and all the spiral stuff projections over the head. Do they all have the same feed rate capability or what if not?