Since these are for shop cabinets I thought I would post here.
Went to town yesterday and checked HD to see if they had any wooden drawer pulls. Only thing they had was knobs.
I went of to the Millwork section and found these
20220127_113324small.jpg
Some sort of architectural trim.
Anyway, I thought I could cut these down rather than trying to make something on the router table.
20220127_124432small.jpg
Ripped them down the middle on the band saw
20220127_143345small.jpg
Then cut them in half. They were $6 apiece but I got four out of each one.
I think they are going to work great for drawer pulls.