Hi,
I am trying something new and need to ask for some help. I have a large quantity of poplar that I want to mill into 2" car decking for a loft floor. The floor will be supported by 6"x8" DF beams every 4 feet. The underside will be left visible. I would like to mill the T&G on my SCMI T160 with a power feeder. I have not been able to find a suitable cutter for this, I am sure this is an easy question for many folks on this forum.

Since the planks will be rough ripped on my table saw, I hope that I can setup the shaper to size the final width on the shaper, maybe by putting a fence on the outside for the second pass?

I appreciate any advise you can offer.

thanks,
Chris