Has anyone used Arauco Plywood for cabinet carcass's? This is for own use. 3/4 will not be available at any Borg or Blue Place till January, and at a substantially higher cost than the 80$ sheet it's listing now. Local WW place only does 5 foot sheets of Birch for 150, and my cut list is laid out using 8 foot sheets. Local builder supply is quoting me https://na.arauco.com/en/p/araucoply...aucoply_sanded at 70/sheet, but can't tell me what grade. I'm not yet frantic enough to consider MDF or particle, but I do have a deadline on this. Face frame, already have the oak doors and other parts built, milled, cut, sanded, and ready. Same issue with 1/2, there is none to be found. Thinking of going down there to look, but it's a pain in a drive, and a same amount of work for them to fork it off their top shelf. Another part of me is saying order their whole stack before any one else figures out they have 3/4 in stock. But it's pine....don't really care what it looks like, but I've never had a good experience with pine plywood of any grade or thickness. Too bowed, curved, warped.