I am building a polebarn and I am putting a 20x30 room in for my wood shop, I am trying to decide how to run 220 outlets, I currently have a dust collector, tablesaw, bandsaw, drill press, radial arm saw, and Vertical Mill that all use 220. I am trying to decide how to layout outlet locations. My old shop had all designated outlets for each machine, however I am not sure if that makes sense with my new bigger shop, I am also unsure of layout right now. since I never run more the the dust collector and 1 other machine I am considering putting in like 4 circuits one for each corner. and a designated outlet for dust collector. I would put in outlets like every 6ft to make sure I can move machines around until I find a layout I like.
Any advice on the layout? my old smaller shop I ran the planer out the back door and I think I will keep that concept here (when its warm out) so the planer will be on the top right in the picture. any advice on dust collector placement? I normally use the dust collector on the tablesaw, jointer and planer, I am thinking maybe put the dust collector on the right wall put tablesaw in center and jointer planer can both run out the door for long pieces on top right. However I am open to ideas.