Spindle moulder sander head Braun Schleiffix

[Albert Lee]

Just wondering if anyone on this forum has one and your thoughts on them?

D4A7F4B5-0F9A-45DB-A66C-AA9254472126.jpeg

https://youtu.be/s2_on2agKxg

I do have a belt sander but due to the size of my workshop it is positioned so I can only use the flat side of the sander. If this works well I might as well get rid of my sander.

[Richard Coers]

Put wheels under the belt sander and move it out to use it better. A non-oscillating drum sander goes through abrasive really quickly.

[Greg Quenneville]

A friend had one for his Felder combo and mentioned that the slowest spindle speed was still much too fast. If I remember correctly, you have the electro spindle on your SCM? Maybe you can dial down to an appropriate rpm

[Bobby Robbinett]

You would be better off with a table mounted brush edge sander or a profile sander.

[Rod Sheridan]

I have a couple of the Felder Schlefix bobbins for my shaper.

I use them for curve sanding at 3,000 RPM with the curve guard.

They work fine….Regards, Rod.