Results 1 to 3 of 3

Thread: Sketchup Help - Transparency

  1. 10-29-2021, 9:33 PM #1
    tim walker
    tim walker is offline [OP] Contributor
    Send a message via Yahoo to tim walker
    Join Date
    Apr 2004
    Location
    Comfort, TX
    Posts
    557
    Blog Entries
    1

    Sketchup Help - Transparency

    I have created this drawing but I do not want it to be transparent like shown, I want solid parts. When I go to materials, it shows opacity for all of these colors at 100% which should yield a solid piece. Anybody have suggestions as to how to remedy this?

    Ashampoo_Snap_Friday, October 29, 2021_20h26m17s_017_.jpg
    Tim in Hill Country of Texas
    Reply With Quote Reply With Quote
  3. 10-29-2021, 9:38 PM #2
    Paul F Franklin
    Paul F Franklin is offline Contributor
    Join Date
    Jul 2007
    Location
    NE OH
    Posts
    2,626
    It looks like you have the back edges mode turned on. In the styles toolbar make sure you have "shaded" selected, not back edges (or x ray).
    --I had my patience tested. I'm negative--
    Reply With Quote Reply With Quote
  4. 10-30-2021, 1:16 PM #3
    tim walker
    tim walker is offline [OP] Contributor
    Send a message via Yahoo to tim walker
    Join Date
    Apr 2004
    Location
    Comfort, TX
    Posts
    557
    Blog Entries
    1
    It was back edge, not sure how I turned it on but thanks for the advice.
    Tim in Hill Country of Texas
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules