Results 1 to 2 of 2

Thread: Dewalt dw734 planer making slightly concave cuts

  1. #1

    Dewalt dw734 planer making slightly concave cuts

    Over ~48" of board length, I get about .005" of "dipping" in the board. This seems like an acceptable amount, but gluing boards up can leave a slight gap without tight clamping. Is this normal? Will a "better" planer reduce this?

  2. #2
    Join Date
    Nov 2009
    Location
    Peoria, IL
    Posts
    2,566
    A little confused by the term dipping, but it's the wood moving, not the machine. It's always best to remove material equally from both sides of the board.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •