Page 3 of 3 FirstFirst 123
Results 31 to 33 of 33

Thread: Motor for Router Table

  1. #31
    Join Date
    Mar 2003
    Location
    SE PA - Central Bucks County
    Posts
    58,256
    Quote Originally Posted by Alex Zeller View Post
    I would think something like a flex pipe for a dryer connected to the bottom would be all that's needed to pull in fresh air but not be too much to impact a dust collector if the spindle is inside a box for dust control.
    I mentioned air cooled because you really cannot invert the water cooled versions I suspect...although I could be wrong about that.
    --

    The most expensive tool is the one you buy "cheaply" and often...

  2. #32
    Join Date
    Apr 2006
    Location
    Kansas City, MO
    Posts
    809
    Water cooled spindles are pumped coolant and as long as the air is purged should have no issues running in any orientation.

  3. #33
    Join Date
    Nov 2016
    Location
    Itapevi, SP - Brazil
    Posts
    632
    I use Bosch MRF23EVS for my router table: link from Amazon.

    Plenty of power and it avoid a special router base plate as I attached directly the router and its fixed base at a DIY base (it is possible to adjust cut deep from the bottom of the base).
    All the best.

    Osvaldo.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •