Hey guys so I have a Sawstop 3hp PCS. Currently for plywood/melamine I run a fairly cheap 80 tooth Freud/Diablo blade. I have a chance to sell it to a friend and upgrade, even though it's been great so far to be honest.
I was looking at 2 different CMT blades and was hoping to get some advice.
https://taytools.com/collections/sup...erf-283-680-10
https://taytools.com/collections/sup...erf-281-681-10
Seems like one is perfect for plywoods and pretty good for melamine and the other is the reverse (the Triple Chip Grind). I was hoping to just have one blade for both, but maybe that isn't an option. I'm also open to Ridge Carbide or other recommendations if you think there's one blade that really shines at all of these tasks.
Side question, I've currently been using the Sawstop 40 tooth blade that came with the saw for all of my general cuts, not rips or fine finish. Is this blade worth sharpening when it gets dull or should I ditch it for a Ridge/CMT/Forrest?
Thanks!