Hi,

After doing some searching.. it looks like I can go with one AX style belt to replace all three L type belts on my unisaw.

I saw someone used a single 3VX or 5VX belt, but those fit differently in the pulley (https://blog.micrometl.com/hvac-the-basics-of-v-belts/). His real life experience says this works too, regardless what the article says. Anyway, I think I'll go with a single AX considering the HVAC site cited above states that the VX belts aren't needed until you get into the 10 HP range.

Wondering if anyone has done something similar.

cheers,