Hi,
I'm going to be building a countertop out of 8/4 or 6/4 walnut with a L and an under mount sink. (6 ft x 9 ft, measured on the wall)
I'd like to have a completed template built on site and build the L at my shop. I'd like to use a miter, cut with my tracksaw. My thoughts, based on talking to others / looking around online is to glue the miter joint with epoxy and dominoes. Let the two sides of the L float with hardware. Clamp the miter cut with countertop clamps. Leave a small gap between drywall and countertop.
I'm still trying to figure out finish.
What should I be thinking / where should I look to make sure I understand all the variables? Recommended videos or books? Is there something I'm not thinking of?