Originally Posted by
Joe Calhoon
Mark, one big advantage of slider next to the blade is the ability to use a double miter. This gets a lot of use on my full length slider and is my go to for any small angle work and small straight cuts. I do a lot of curve work and it’s great for joining curve moulding to straight. That always involves two angles and with the double miter it’s easy to go back and fourth between angles. If I ever downsize I think I could make a subtable for the T17 to use the
Joe, thanks for the picks. Would love to get the quadrant, i know you show the Martin here but is it difficult to put on and take off?
also i would love if my saw had the ability to put the xcut fence in the middle of the outrigger, I find I do a lot of small and medium size cuts and it’s always a kinda uncomfortable reach when the fence is in the forward position, i like it in the rear position (operator side) for the smaller cuts but I always find myself moving it to the forward position at some point, a middle position would be a good compromise I thought I saw a saw that could do this was it a Martin?