Quote Originally Posted by Mark e Kessler View Post
Joe that’s a good point, although I can make it work I think I run into a scenario almost every project where having a little bit of table to the left of the blade would be benefit. Looks to be a good 6”, that might cause a little pain if you are doing smaller furniture pieces but am sure it’s workable

to
Mark, one big advantage of slider next to the blade is the ability to use a double miter. This gets a lot of use on my full length slider and is my go to for any small angle work and small straight cuts. I do a lot of curve work and it’s great for joining curve moulding to straight. That always involves two angles and with the double miter it’s easy to go back and fourth between angles. If I ever downsize I think I could make a subtable for the T17 to use the double miter.
FB89BB71-3554-445C-ACF8-5ECA535BF08B.jpg
3336B2D3-D3C5-4068-A90C-1BE199DFBE74.jpg
And here is a example of where the slider next to blade is not so handy.
33A06254-E266-481E-8F50-1E3F9392725A.jpg