Hi all, I am building a base for an outfeed table and wanted your advice. Not to scale pic attached. All members are made of two laminated pieces of 3/4" ply. How would you recommend securing them to each other where the shorter members are perpendicular to the two long members? I have thought about pocket holes on either face (8 in total) and treat it like 3/4" single ply vs 1-1/2" ply and just use 1-1/4" pocket hole screws. My other thought was to just use 3" lag screws or deck screws from the front. Open to all recommendations. Second pic is scaled final configuration
Cross Member.jpg Actual.jpg