After a ~7 month wait I finally got my 16" Grizzly G9953ZX jointer which is staged in my garage workshop. The garage floor, like most, is sloped toward garage door openings. I want to ensure the unit is; 1) level, and 2) not going to conform to any out of flat / twist condition the concrete floor may have as I know cast iron will conform to what it is sitting on. I am looking at using machine leveling mounts. Has anyone used machine level mounts on a large jointer or other similar large heavy piece and have suggestions on how they did setup? Once this is done I will then do final setup to ensure coplanar and squareness of the table/fence. Unit weight is ~1,650 lbs. Any suggestion or input would be appreciated. Yes, I maybe be a bit OCD but trying to do the right thing as well.