3hp Baldor single phase capacitors

I bought this PM 66 that had been sitting for about 8 years in a garage. When I got it home I found a silver capacitor 97f9632 25 uf + 8 - 6%. It would not start the saw, it just hummed. I'm looking for capacitor size and whether it takes a start and run capacitor. There are three wires coming from the motor with one going through the centrifugal switch. The saw dates to 1987 (sn 876672038) and it took a bit to free it all up. I replaced the 3 belts as well. While changing the belts I found the motor pulley about 1/2-3/4" off the arbor pulley and had to adjust it lo align the bels. I guess someone had been tinkering with it. I was hoping someone has been down this rabbit hole and may have the info handy. Thanks, Bill