Hi all, I have a few blades for my LA jack that I keep at different angles 25°, 50° and 90°. I sharpen on one of two guides I have and for accuracy's sake I wanted to write on the backside of the blade relevant information: blade angle, sharpening jig and for the veritas sharpening jig the wheels layout for microbevel. I fully realize that a lot of you will roll your eyes at this, but for the sake of my OCD I must plod on.
Sharpies rub out after handling for sharpening.
I tried a label maker, but labels are thick - it raises the plane iron above its bed. I am worried that It will contribute to blade chatter.
anyone else deal with this? any solutions?
I don't fancy engraving the metal because if I do it it will be ugly, and it is permanent.
thanks!