i know a few of you are experts with the bowmouldmaster... i need some guidance. (joe, peter!)
first of all - i cooked the bearing in my guide. has anyone replaced that bearing, and if so, do you have an advice on how to go about it?
second, can the bearing guide plate be mounted below the cutter, rather than above it? i have an odd situation where i really need a depth-adjustable bottom bearing surface, and if i can put the bearing guide plate at the bottom rather than the usual top, it would be ideal.
finally -- which spacers do you use on either side of that bearing to ensure it's spinning freely?
thanks.
--- dz