Hi all,
I recently picked up a robland nx410 combo machine, and I have been having a hard time getting the outfeed/infeed tables adjusted.
The machine only seems to have adjustments on the left side of the beds (the side you work on). The other side that swings open to form the planer has no adjustments.
The only way I can get the beds coplanar is if the outfeed table is a bit higher than the knives. From everything ive read, the outfeed table is supposed to be on the same level as the knives, and then the infeed table is set to match. If I get the outfeed table level, the closest I can get the infeed table still leaves me w/ about 1/16" gap at the beginning of the infeed, and no gap at the cutterhead.
Ive had little luck with Roblands customer service and Im getting at my wits end. If they were non tersa knives I could adjust them to be parallel with the outfeed table, but the knives have no adjustment.
Does anybody have any advice? Has anybody dealt with this situation before?