I glued some 20" x 27" unbacked cherry veneer with Titebond Coldpress Veneer glue. In spite of using every clamp in my shop and 5 cauls I still ended up with a couple of areas where the veneer didn't adhere to the substrate. The one other time this happened I tried injecting some glue into the void and then clamping but the results weren't good. I don't know if ironing the areas would melt the glue or not. The veneer was applied yesterday and Titebond says to allow about 72 hrs for full cure.
Does anyone have any experience with this product regarding using heat to melt it? Any other suggestions would also be appreciated.