There was a tip in the April 2021 American Woodturner (AAW) about making a triangle sharpening jig to use with sharpening the 3 face point tool. It said to drill a tight hole to insert the tool to provide jig to sharpen. I have drill bits by 64ths, but would not provide a tight fit to hold the tool, so I came up with using a screw to "index" the tool to the jig. Then the obvious answer came to me that I needed to make a triangle handle that would permanently index the tool and also give better holding when using the tool. The photo shows rough initial work. The triangle handle is 1-1/4" side and next one will be 1-1/2" side to provide a little larger handle. Handles only need to be about 6" long for single hand use. Ferrels are short section of 1/2" copper coupling. Both jig and triangle handle work well to grind the point and hope you get the point.Point tool with Triangle handle.jpg Tools made from 1/4" tool steel.