Hey all,
So I recently acquired a Xenetech 1625 and then the next week a customer asked if I would be able to provide 500 engraved bricks for their school. I have a Xenetech 912 which isn't tall enough to fit a brick in so I would have to use the 1625 which I haven't even installed/tried to fight Xenetech for their software which I've heard can be problematic.
The question is two fold-
Can a Xenetech 1625 reliably route out/engrave 500 bricks without falling apart or would that damage the machine?
Is it possible to get the software from Xenetech as I would be installing it on a new computer.
Thank you in advance for your patience; I don't have a lot of knowledge when it comes to rotary engraving, I just parrot what I've seen.