Here's a small piece made from the maple crotch I cut up a week ago. Not completely done with the finish yet but wanted to show off the figure.
6" diameter and 5" tall. Wall thickness a little over 1/8"....WOP finish
20210328_170328.jpg
Here's a small piece made from the maple crotch I cut up a week ago. Not completely done with the finish yet but wanted to show off the figure.
6" diameter and 5" tall. Wall thickness a little over 1/8"....WOP finish
20210328_170328.jpg
~john
"There's nothing wrong with Quiet" ` Jeremiah Johnson
Pretty piece, John.
1/8" must have been a little hairy to turn.
Nicely done.
Be Blessed
George
Thanks George
I must admit I was a little nervous but all is well. It's a bit thicker toward and around the bottom.
~john
"There's nothing wrong with Quiet" ` Jeremiah Johnson
At what speed did you use for something that thin,very cool vase by the way
Thanks Tim
Well, my speed varies throughout. I complete the outer profile first at about 1000 rpm. Then turn it around and hollow at about 1100. But when I'm going for final thickness, I ramp it up to about 1800 and attack with the point of my skew. Driving down into the vessel while keeping my eye on the outer profile, and follow that....if that makes sense.
~john
"There's nothing wrong with Quiet" ` Jeremiah Johnson
Beautiful piece. Love the figure, spalting and color!
"All that is necessary for the triumph of evil is that good men do nothing."
“If you want to know what a man's like, take a good look at how he treats his inferiors, not his equals.”
Thanks Frederick
It was fun. I enjoyed my day today
~john
"There's nothing wrong with Quiet" ` Jeremiah Johnson
I can't imagine turning something like that at that speed,not that experienced yeat.
Nice work. Looks like you got a pretty nice cut working with something with substantial decay. Did you treat the wood with anything to stabilize it? I find that spalted maple often has patches that are quite prone to tearout.
Best,
Dave
Thanks Dave....yup, I was pretty worried about running into a bunch of punky wood when I decided to cut into that crotch piece. It's been sitting in my shop for over 5 years. But to my surprise there wasn't much. Lucked out. Had a couple of tear-out patches but just kept my tools sharp and didn't have to harden it. And of course, the 80 grit helped with the tough spots
~john
"There's nothing wrong with Quiet" ` Jeremiah Johnson
Great job on a beautiful piece of wood...well done and welcome back!!
Nice wood and shape. Yesterday I mounted a very similar piece on my lathe and have been pondering the best shape to show off the spalt. Hopefully I will get to it today. If I do I'll post a shot here as well so we can compare the beauty of the wood.
Pete
* It's better to be a lion for a day than a sheep for life - Sister Elizabeth Kenny *
I think this equates nicely to wood turning as well . . . . .
Great piece! It looks like it must have been a good size blank to start with. It's hard to find larger spalted maple chunks of wood.