Instead of kindling....

Had a stash of strips...from ripping a few boards to width...usually 3/4-1" thick....some a bit wider than others....and sitting all over the shop...
Area between the bandsaw's riser, and the blade is ~12"......ran all them strips through....those that were too short were tossed.....the rest were glued up into a panel...
Cutting board, start up.JPG
Then all the rest of the operations....results?
Cutting Board, 1st coat, top.JPG
Topside..and ..
Cutting Board, 1st coat, underside.JPG
Underside.....2 coats of Mineral Oil.....