Results 1 to 2 of 2

Thread: Alternative positioning for INCRA LS router fence on TS wing

  1. #1

    Alternative positioning for INCRA LS router fence on TS wing

    Crazy idea? Any pitfalls I may be missing?


    6E825EC3-F4CB-40F8-A069-1561C6DD0D4B.jpg

    trying to maximize ripping capacity without having to remove LS.

    limited space workshop so left wing extension out of the question, Right wing far end would require moving saw for use, no space for separate router table.

    looked on tHe forums and could not find much, other than a couple pictures.

    Any suggestions welcomed

  2. #2
    Join Date
    Mar 2003
    Location
    Upland CA
    Posts
    5,548
    Cannot comment on the Incra fence but that is the way I did it on my unisaw. I used a home made fence with a pivot on one side and clamp on the other. I have a couple other router tables, and mostly use this with no fence and a bearing equipped bit for roundovers and the like.

    The only problem I see is that I have to remove it to move the saw fence past 20" or so.
    Rick Potter

    DIY journeyman,
    FWW wannabe.
    AKA Village Idiot.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •