I switched to a sawstop PCS about 3 weeks ago. I degreased it and coated it with Glidecoat. I got it out today and it has a sizable amount of rust on it. I must be doing something wrong. I didn't cut that much wood on it, so I hadn't re-applied another coat since unbundling it. Any advice on this and any advice on what to do about the rust on it?
I have no problems with other equipment including new jointer and old shaper, same process. The only thing I can figure is that the wood rubbed off the coating, and it rusted, perhaps I need to re-apply glidecoat ever weekend?
Attached pictures were after i soaked it with a WD40 degreaser today, cleaned it with mineral spirits, and then re-glide-coated it.