Hello, fellow Creekers. I need to replace the outfeed locking handle on an old 12 inch SCMI F3A jointer. The teeth inside the handle cap are stripped. Luckily the mating teeth on the locking shaft look good. The handle is metal and about 5 inches long. The shaft it goes onto is just over 7/8 in diameter, or around 23mm. The teeth are about 3/8 inches long, and then there's another 3/8 of smooth shaft before it goes into the jointer. I'm not hung up on a specific handle form - a lever or big knob would be fine. Any recommendations on where I can go to get something to replace it? Ordering replacement parts form SCMI seems nearly impossible. Thanks, Pete


IMG_7910.jpgIMG_7911.jpgIMG_7912.jpgIMG_7913.jpgIMG_7914.jpgIMG_7915.jpg