So as some of you may have seen, I plan on buying a proper table saw. Unfortunately I only have 110v service out in the garage and will have to run a 220 line out to it. That is where it gets interesting. I have to have it run from the opposite side of the house (breaker box), up the wall, across the attic, down a wall and out the side of the house (two story house) to where the other line 90's down into the ground and then over into the garage. This is the same path as the current 110v line. Probably around 100' total and I know it's not going to be cheap. I am just dreading the estimate and trying to think of ways to save money on it. Maybe instead of going down the wall in the back of the house, make the new drop run outside of the house inside of PVC? I don't know though, I am just...stumped and quite frankly dreading this.

If any of you guys have dealt with this before or have advice, I would love to hear it. I really want the 3HP motor and not be stuck with the 110v motor.