Hi guys,
So if any of you have been following the journey so far with the Red/Black laser, then I finally got the new replacement laser head along with a complete set of mirrors. So far so good.
Everything has been set up and laser tube is hitting mirror 1 perfectly (not necessary i know, but it looks good) and this is where it gets interesting/annoying.
If I pulse when mirror 2 is in the upper left corner (closest to mirror 1) and adjust so that it hits dead center and then run mirror 2 to the lowest left corner and pulse. The spot is waaaay off.
If I pulse when mirror 2 is at the lower left corner and adjust so its dead center and then run it back up closest to mirror 1, then its way of target
I can not figure out, where the fault is
Anyone got any ideas? Tips or tricks? Because this machine has not been in action for a few months so far