I wanted a 2" chisel for something that I want to do. I purchased a standard Narex Chisel. Nothing special.


new_narex_2_inch_chisel.jpg

If I remember correctly, these things have some kind of mystery coating (lacquer perhaps) that I should remove...

My intention is to start with Mineral Spirits. I understand that many things that remove the lacquer will also remove the printing on the blade. I could also try a brass brush (since I have them).

I can also try acetone if that fails. Then again, I won't be doing fine joinery mostly with this chisel. Will still flatten the back for the sake of sharpness and I do not want to gum-up my stones.

I have a project in mind, hope it works out.