I'm working on a little stool using scrap QSWO and using the Homestead process for finishing. I've used this a number of times and it really works well. For those considering trying it out but still unsure, here's a simple 1-2-3 guide.
Step 1 - Sand to 220 grid and blow out all the pores.
IMG_0629.jpg
Step 2- Apply dye. I dissolve the dye in DNA instead of water as it has less impact on raising the grain. I use either a Golden Oak (pictured) or a Reddish Brown depending on how I want the piece to look and how much "Pop" I want from the grain. I should note that this is the part where a first time user of this process will be certain the project is ruined. When dry, the color can be pretty bright. Have faith. when dry, lightly sand with a very fine grit or use a Scotchbrite pad.
IMG_0632.jpg
Step 3 - Apply glaze. This is Minwax #2750 Jacobean. I brush it on liberally and after a bit wipe it town with an old dish towel or other thirsty rag. I tend to rub it out across the grain or in circles so I don't pull it out of the pores. This is the part where the first time user of the process starts breathing again with the realization that the project isn't ruined.
IMG_0633.jpg
As you can see, the dye really makes the ray flake pop. I need to let this dry for a couple days prior to finishing it. A clear finish makes the figure in the wood really come to life. The plan is a coat of clear Watco Danish oil, a couple coats of Garnet Shellac, and then semi gloss polyurethane for the top. It's a step stool and I need the top to be durable.
IMG_0634.jpg
I'm a real believer in this process. I have a few vintage arts and crafts pieces from the turn of the century and this really nails the look.