Router speed chart - Milwaukee

[Bob Cooper]

The manual doesn’t specify how fast each setting is. I assume it’s a linear scale but if it were printed up from the manufacturer seems like it would be better/easier.

I ask because I’m getting ready to use a big raised panel bit

anyone have a pointer to a table?

this is their big 3HP model

[Dick Mahany]

My Milwaukee 5625 has the following speed chart label on the motor

IMG_6477.jpg

When using large diameter panel raising bits I always used the slowest several settings.

[Bob Cooper]

Thanks Dick....I ran mine at half speed and it worked fine but I’m cutting soft poplar