Got a 3/4 inch Resaw King for my Rikon 10-326. Was cutting a lot of 1/8 inch laminations. Lenox 1/2 inch 3TPI was getting the job done, but wanted to try out Resaw King. Cranked up tension to max and cut was significantly better, although still needed to use planer to smooth face of board afterwards. The problem was that when I began cut the blade would shift perhaps 1/32 of an inch and then follow a perfect straight line the rest of the cut. I thought my blade guide bearings were not the exact same distance from the blade so I adjusted them both to where they were barely touching and rotating a bit when turning the wheels by hand. I thought my bottom guides were properly adjusted also. Maybe I could do better with adjusting the guides. Here is a picture of the cut. bandsaw cut.jpg Any thoughts on the problem? Thanks