Results 1 to 4 of 4

Thread: Best way to cut a saw plate?

  1. #1
    Join Date
    Sep 2019
    Location
    Lafayette, CA
    Posts
    675

    Best way to cut a saw plate?

    A rectangular fragment of a saw plate floating around in my shop was intended as a scraper. It turned out to be perfect to use to extend a saw kerf into the pin boards in half-blind dovetails. I was delighted that the rectangle is exactly the thickness I need for the task (0.025Ē), so it is in use. But itís about an inch wider than it needs to be. Iíd like to trim it down to make a more elegant tool.

    I cut wood. Iím out of my depth when faced with cleanly cutting a tool steel plate along a straight line. What are some options I might already have in my shop?

    I donít have a dedicated metal grinder, but I have a Dremel, cordless drill, and drill press.

  2. #2
    Join Date
    Feb 2016
    Location
    Odessa, Tx
    Posts
    162
    Dremel would work. I cut my first few plates using a grinder and a cutoff wheel. Take your time, keep it cool.

  3. #3
    Join Date
    Sep 2016
    Location
    Modesto, CA, USA
    Posts
    6,323
    abrasive cutting disk in a saw. Watch out for saw dust fires. It will have to be retempered on the cut edge.
    Bill D

  4. #4
    Join Date
    Oct 2007
    Location
    New Hill, NC
    Posts
    2,439
    If I were you I'd invest in a budget quality 4-1/2" angle grinder and use a cutoff wheel with it. Horror Freight has some starting at 13 bucks and going up to $100.

    For a better quality tool, consider Dewalt, Makita, Milwaukee or Metabo. I've used all of them and they are great tools.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •