Hi,

Have some questions about improving my honeycomb area on my 5070.

In looking at where my 0,0 Red Dot falls on the bed, I see I have a lot of wasted space behind that on my honeycomb, see 2.095 inches in attached.

right_side.JPG


I also see that when I go to the 700 limit on my X axis, it goes off the honeycomb and onto the frame.
Left_Side.JPG


Can I unbolt the E stop and slide it towards the back wall, and re-mount it ?
In doing so, would it then readjust and slide the 700x500 limits back based on that E stop ?

I can't slide my honeycomb frame fwd, as I only have 0.15" clearance between outside edge and front rail.

Thoughts, suggestions ?

Cad