Hey everyone I'm new to the forums, but I've been reading 1000s of conversations over the last few months. I've only been woodworking for about 4 months and I'm loving it so far. I'm currently building a new house and have been acquiring additional tools over the last month or so for the new house. Right now it's all just in my shed, but I'll have a full 2 car garage space at the new house dedicated to the woodworking shop.
I'm hoping to get some advice on shop layout, dust collection setup, etc. Here's what I have so far:
Dewalt Table Saw - Swapping this with a 52" PCS Sawstop upon moving in to the new house
Dewalt 3hp Router - Currently built my own router cabinet/table on wheels, but may swap to sawstop setup if space gets tight
Craftsman 48" Jointer - Hand me down from family, runs, but haven't actually used it yet
Dewalt 735x Planer
Metabo 12" Sliding Miter Saw - This is built into a fenceless Miter Station with 4 feet of cabinets to the right and 7 feet to the left
WEN - Ceiling Air Filter
Festool Domino 500
Bosch Dust Extractor
Ridgid ShopVac
WEN Floorstanding Bandsaw - Got it super cheap but I know it's not the best
Ridgid Oscilating Spindle/Belt Sander
Bosch GET75N Rotex style 6" sander
Incra 5000 Miter Sled
Bunch of DeWalt power tools, router, drill, etc
I've also been compiling tons of smaller tools over the last few months, chisels, japanese pull saws, router bits, jigs, guides, etc.
Things I'm looking to buy right away and install day 1 of new home ownership on February 22nd:
Wen 15" Floorstanding Variable Speed Drill Press
Sawstop PCS 52" - kind of debating if the 52" is really necessary, but any input would be great
Makita Track Saw and TSO Square
ClearVue Cyclone CV1800LH - Debating upgrading to 16" Impeller, any thoughts would be great
Planning to use 6" PVC straight along the miter station, one pipe going down to the miter saw, another main going across the ceiling and then splitting off in a bunch of directions going down to each tool as close as I can before shrinking to 4" PVC in order to install 4" iVAC Blast Gates and then to 4" flex hose as short as possible to each machine. I'd love to use the 6" blast gates, but they're crazy expensive and I really want a fully automated system. Any advice you can give would be great regarding the dust collection. It's the part that I'm most worried about getting it right.
Eventually an AVID 4x8 CNC - This might be a few months down the road to make sure it will fit since it's freaking huge!
I've also attached a few images from my Fusion 360 Drawings to show the layout I was thinking about. I would love any helpful input and won't take offense to any criticisms. I'm just looking to ensure I'm doing everything as best I can and not making any huge mistakes.
Woodshop.jpgWoodshop Angled.jpg
Thanks to everyone in advance for taking a look at my setup and helping out! I may have forgotten a few things, but hopefully it's all there.