Mel ,I would be interested to hear how you changed the spindle. I do not have a different spindle, came with a 1 1/4'' . Also have no wrench for the spindle, however some day I may need to know how this works.
Mike, machine came with a “wrench” that was a pipe about 3 or 4 inches in diameter . A rod went through the top of it as a handle to turn it.
Couple of lugs on the pipe engaged the spindle base. Our shaper ,bought used, had the spindle improperly installed . Would have come out
if machine had been run counter clockwise.
The wrench turned a collar that pulled the spindle up from Morse taper
Last edited by Mel Fulks; 03-18-2021 at 2:46 PM.
That seems to be the standard euro arrangement. My casolin and invicta use the same style dual thread retaining nut. I know GOMAD, Bauerle and I believe Martin used the same system as well.
Mike, I will post a few photos of my spindle wrench setup, which may be very similar (identical?) to the Invicta wrench from the sounds of it. If you go back to the previous page and read the attachment I posted from WoodWeb towards the bottom of the page, it explains in detail how to change out this type of spindle.
Still waters run deep.