The challenge here was that I only had one 12' x 20" soft maple board with this figure to create all the components. I resawed off just enough to make the fronts. Then filleted what was left to create the top and sides. The fronts are veneer over ply with secondary woods on the inside. The front is bookmatched from the center, while the carcass waterfalls on both ends. The carcass is 1" thick with the hidden portion being secondary wood laminated to 1/2" of the curly stuff. Dominos were used for joinery. Solid dovetail drawers with Blum undermounts. Hardware is hand forged from common steel stock. Welded steel base.