I have some free 4x4 PT lumber and I want to make some work benches. I have metal clad tops. The parts connecting the legs will be 2 lams of 3/4 plywood. I have 6 legs to cut. I have a 6 foot and 8 foot top but not to be my primary woodwoorking bench.
I have a Bosch jobsite saw, Bosch plunge router, a Dewalt midsize router, a worm drive 7-1/4 saw, multi-tool, chisels etc. My hand saws are a little lame but might be a good way to go?
My first thought is after planing to clamp several together at a time with common cuts using a guide and worm drive saw accross the top, then clean out with multi-tool from the sides and finish with chisels?
Running these 3 foot posts sticking up seems sketchy without a big fixture.
Thoughts for best way for ME to do this?
castle joint.png