I have a new machine with one and I cannot get the air assist [wind connection] to function. I tried a different [RDC6442] controller and it works. Thanks Gene
I have a new machine with one and I cannot get the air assist [wind connection] to function. I tried a different [RDC6442] controller and it works. Thanks Gene
If this is what the controller looks like:
Capture1.JPG
According to the manual it is the Connector CN-2 , pin 5 for Wind for that controller.
Capture2.JPG
But it needs an electric/pneumatic air valve if one was not provided with the laser similar to this Ruida controller:
Capture.JPG
Thanks guys- I have the Ultimate Air assist set up with more mods of my own- I have found several places to enable the 'wind' terminal and have ticked all of them, still no [negative] signal on the terminal... just wondering if there is something I missed. The system works a treat if I provide the negative signal. Gene
I've an S and it will switch a relay when wired with those two wires +24v and wind. It will work just fine. G model should work the same way. it doesn't send a negative signal, it sends 24V to a relay. Turns on or off at the power settings Air on or off.
Woodworking, Old Tools and Shooting
Ray Fine RF-1390 Laser Ray Fine 20watt Fiber Laser
SFX 50 Watt Fiber Laser
PM2000, Delta BS, Delta sander, Powermatic 50 jointer,
Powermatic 100-12 planer, Rockwell 15-126 radial drill press
Rockwell 46-450 lathe, and 2 Walker Turner RA1100 radial saws
Jet JWS18, bandsaw Carbide Create CNC, RIA 22TCM 1911s and others