I just bought a Grizzly G0855. I borrowed a Veritas straight edge and was able to get a .005" feeler under the straight edge when measuring corner to corner on the outfeed table. Do you guys think this is acceptable? .005" over 36" is pretty damn flat but the instructions call out a max of .003. That said the straight edge is only rated to .003 over its length, maybe I need to get my hand on a better straight edge?
Also I've been having a hell of a time trying to get the infeed/outfeed tables aligned. Most instructions I look at just say something generic like "use shims". Can you guys recommend a more detailed walk through of getting the beds aligned?