Page 2 of 2 FirstFirst 12
Results 16 to 19 of 19

Thread: boggs vacuum box

  1. #16
    Join Date
    Apr 2017
    Location
    Clarks Summit PA
    Posts
    918
    Quote Originally Posted by Tom Bender View Post
    If you make more holes and over the full width you could then cover the excess ones with package tape for narrow stock.
    Nice modification Tom

  2. #17
    Join Date
    Apr 2017
    Location
    Clarks Summit PA
    Posts
    918
    Quote Originally Posted by Phil Mueller View Post
    Thanks for sharing Mark. Had not seen that technique before. I don’t do shop sawn veneer much, but the minimal work to put it together would make it worth it even for a one time need.
    You are welcome Phil. A cheap substitute for a wide belt sander.

  3. #18
    Join Date
    May 2015
    Location
    NW Indiana
    Posts
    1,002
    Thx for the info Mark. That's new to me and I'll be using it soon on a dresser project with curved sides.
    You know, the worst ain't so bad when it finally happens.
    Not half as bad as you figure it'll be before it's happened.
    - Bob Curtin

  4. #19
    Join Date
    Apr 2017
    Location
    Clarks Summit PA
    Posts
    918
    Quote Originally Posted by Bill Carey View Post
    Thx for the info Mark. That's new to me and I'll be using it soon on a dresser project with curved sides.
    You are welcome Bill, I will look forward to your build

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •