Porter Cable router got cross threaded, not the collet side. Need to get the right size die. It is for the standard size spindle. Can someone please let me know what I need?
Thank you for your time!
Chris
Porter Cable router got cross threaded, not the collet side. Need to get the right size die. It is for the standard size spindle. Can someone please let me know what I need?
Thank you for your time!
Chris
Have you looked up the spindle to see if they listed the part number along with the thread data? Which model number?
690 is the model
Perhaps a thread file will do. Is that 1/4 or 1/2? unlike you I do not have all model numbers memorized.
Bil lD
15/16 sound good? maybe 16, 18, 20, 22, 24, 32 tpi would be a standard.
Bil lD
Last edited by Bill Dufour; 10-12-2020 at 12:21 AM.
Do you have a thread pitch gauge? https://en.m.wikipedia.org/wiki/Thread_pitch_gauge
Auto parts store has them.
Is this the spindle? Pic is not good but should be able to tell.
If it is you can try calling them about the threads.
https://www.repairtoolparts.com/port...ter-shaft-assy
Boy, I say boy! Ya' goin' about it all wrong!
Ya' gotta look at dis like uh tailuh-made excuse tuh buy uh brand spankin' new rowtuh!
-- Andy - Arlington TX
Last edited by Andy D Jones; 10-12-2020 at 3:14 PM.
I doubt you will easily find a tap the right size. When you do it's likely an industrial quality one. It may well be cheaper and easier to replace the armature in that router.
How bad is it? I’d probably just file the start thread by hand to repair it.
Bumbling forward into the unknown.
Once you tear, break, or cross thread something, there is no steel left to thread. If you try and run a die, it may or may not catch at the same place and anything that looks like new threads will not line up with good threads further down. That armature is toast.
I am trying hard to figure out how one would cross-thread this collet. I insert bits and thread/tighten the collet by hand until snug and then finish with the wrenches.
--
The most expensive tool is the one you buy "cheaply" and often...
How do you cross thread a router collet nut? yeek