Hi,
I am looking for some help/info from anyone who has used Target Coatings EM1000 sanding sealer. I have used it a few times on the project I am working on and so far, I have gotten the same results every time I've used it. I am not sure if it is fisheye or if its just how the sealer lays out after I spray it. I will include some pics from the tabletops I sprayed today. While they are real noticeable when wet and drying, they are not so obvious once the sealer is cured.
I have table bases that I used General Finishes Dye stain, with a GF wood stain over the top of it. Once I sprayed the EM1000 on the bases, I got the spots.
The tabletops have GF Dye stain only, but when I sprayed the EM1000, I had the same issue.
So far, to try to resolve the issue, I have cleaned my gun (I only spray waterborne finishes with this gun), and on the bottom side of one of the tabletops, I sprayed a washcoat of shellac before the sealer and still had the same issue.
Can anyone tell me if this is typical of the sealer, or give me some more ideas on possible causes?
Here's some pics...
20200927_182902.jpg20200927_142237.jpg
Thanks!